Seated Head Harness Neck Resistance

Seated Head Harness Neck Resistance is a intermediate-level isolation in the strength category that primarily works the neck. It is performed with other equipment.

How to do it

1. 1Place a neck strap on the floor at the end of a flat bench. Once you have selected the weights, sit at the end of the flat bench with your feet wider than shoulder width apart from each other. Your toes should be pointed out.
2. 2Slowly move your torso forward until it is almost parallel with the floor. Using both hands, securely position the neck strap around your head. Tip: Make sure the weights are still lying on the floor to prevent any strain on the neck. Now grab the weight with both hands while elevating your torso back until it is almost perpendicular to the floor. Note: Your head and torso needs to be slightly tilted forward to perform this exercise.
3. 3Now place both hands on top of your knees. This is the starting position.
4. 4Slowly lower your neck down until your chin touches the upper part of your chest while breathing in.
5. 5While exhaling, bring your neck back to the starting position.
6. 6Repeat for the recommended amount of repetitions.

Muscles worked

Primary muscles in filled badges, secondary in grey. Tap for more exercises per muscle.

Tips and common mistakes

• •Focus on the muscle contraction and control the eccentric (lowering) phase.
• •Add load only once you complete all reps with good form — progressive overload.
• •Initiate the pull from the target muscle rather than jerking with body momentum.
• •Prioritize full range of motion over heavy weight with partial reps.

Sets and reps

For hypertrophy: 3–4 sets × 8–12 reps with 1–2 reps in reserve (RPE 7–9) and 1–2 minutes rest. For strength: 3–5 × 4–6 with longer rest.