Reverse Cable Curl
Reverse Cable Curl is a beginner-level isolation in the strength category that primarily works the biceps. It also recruits the forearms. It is performed with cable.
How to do it
- 1Stand up with your torso upright while holding a bar attachment that is attached to a low pulley using a pronated (palms down) and shoulder width grip. Make sure also that you keep the elbows close to the torso. This will be your starting position.
- 2While holding the upper arms stationary, curl the weights while contracting the biceps as you breathe out. Only the forearms should move. Continue the movement until your biceps are fully contracted and the bar is at shoulder level. Hold the contracted position for a second as you squeeze the muscle.
- 3Slowly begin to bring the bar back to starting position as your breathe in.
- 4Repeat for the recommended amount of repetitions.
Muscles worked
Primary muscles in filled badges, secondary in grey. Tap for more exercises per muscle.
Tips and common mistakes
- •Focus on the muscle contraction and control the eccentric (lowering) phase.
- •Add load only once you complete all reps with good form — progressive overload.
- •Initiate the pull from the target muscle rather than jerking with body momentum.
- •Prioritize full range of motion over heavy weight with partial reps.
Sets and reps
For hypertrophy: 3–4 sets × 8–12 reps with 1–2 reps in reserve (RPE 7–9) and 1–2 minutes rest. For strength: 3–5 × 4–6 with longer rest.