Wide Stance Barbell Squat
Wide Stance Barbell Squat is a intermediate-level compound in the strength category that primarily works the quads. It also recruits the calves, glutes, hamstrings and lower back. It is performed with barbell.
How to do it
- 1This exercise is best performed inside a squat rack for safety purposes. To begin, first set the bar on a rack that best matches your height. Once the correct height is chosen and the bar is loaded, step under the bar and place the back of your shoulders (slightly below the neck) across it.
- 2Hold on to the bar using both arms at each side and lift it off the rack by first pushing with your legs and at the same time straightening your torso.
- 3Step away from the rack and position your legs using a wider-than-shoulder-width stance with the toes slightly pointed out. Keep your head up at all times as looking down will get you off balance, and also maintain a straight back. This will be your starting position.
- 4Begin to slowly lower the bar by bending the knees as you maintain a straight posture with the head up. Continue down until the angle between the upper leg and the calves becomes slightly less than 90-degrees (which is the point in which the upper legs are below parallel to the floor). Inhale as you perform this portion of the movement. Tip: If you performed the exercise correctly, the front of the knees should make an imaginary straight line with the toes that is perpendicular to the front. If your knees are past that imaginary line (if they are past your toes) then you are placing undue stress on the knee and the exercise has been performed incorrectly.
- 5Begin to raise the bar as you exhale by pushing the floor with the heel of your foot as you straighten the legs again and go back to the starting position.
- 6Repeat for the recommended amount of repetitions.
Muscles worked
Primary muscles in filled badges, secondary in grey. Tap for more exercises per muscle.
Tips and common mistakes
- •Keep your core braced and your spine neutral throughout the movement.
- •Add load only once you complete all reps with good form — progressive overload.
- •Press through the full range and avoid snapping the joints into lockout.
- •Prioritize full range of motion over heavy weight with partial reps.
Sets and reps
For hypertrophy: 3–4 sets × 8–12 reps with 1–2 reps in reserve (RPE 7–9) and 1–2 minutes rest. For strength: 3–5 × 4–6 with longer rest.