Bent Over Two-Arm Long Bar Row

Bent Over Two-Arm Long Bar Row is a intermediate-level compound in the strength category that primarily works the mid back. It also recruits the biceps and lats. It is performed with barbell.

How to do it

1. 1Put weight on one of the ends of an Olympic barbell. Make sure that you either place the other end of the barbell in the corner of two walls; or put a heavy object on the ground so the barbell cannot slide backward.
2. 2Bend forward until your torso is as close to parallel with the floor as you can and keep your knees slightly bent.
3. 3Now grab the bar with both arms just behind the plates on the side where the weight was placed and put your other hand on your knee. This will be your starting position.
4. 4Pull the bar straight up with your elbows in (to maximize back stimulation) until the plates touch your lower chest. Squeeze the back muscles as you lift the weight up and hold for a second at the top of the movement. Breathe out as you lift the weight. Tip: Use a stirrup or double handle cable attachment by hooking it under the end of the bar.
5. 5Slowly lower the bar to the starting position getting a nice stretch on the lats. Tip: Do not let the plates touch the floor. To ensure the best range of motion, I recommend using small plates (25-lb ones) as opposed to larger plates (like 35-45lb ones).
6. 6Repeat for the recommended amount of repetitions.

Muscles worked

Primary muscles in filled badges, secondary in grey. Tap for more exercises per muscle.

Tips and common mistakes

• •Keep your core braced and your spine neutral throughout the movement.
• •Add load only once you complete all reps with good form — progressive overload.
• •Initiate the pull from the target muscle rather than jerking with body momentum.
• •Prioritize full range of motion over heavy weight with partial reps.

Sets and reps

For hypertrophy: 3–4 sets × 8–12 reps with 1–2 reps in reserve (RPE 7–9) and 1–2 minutes rest. For strength: 3–5 × 4–6 with longer rest.