Close-Grip Front Lat Pulldown

Close-Grip Front Lat Pulldown is a beginner-level compound in the strength category that primarily works the lats. It also recruits the biceps, mid back and shoulders. It is performed with cable.

How to do it

1. 1Sit down on a pull-down machine with a wide bar attached to the top pulley. Make sure that you adjust the knee pad of the machine to fit your height. These pads will prevent your body from being raised by the resistance attached to the bar.
2. 2Grab the bar with the palms facing forward using the prescribed grip. Note on grips: For a wide grip, your hands need to be spaced out at a distance wider than your shoulder width. For a medium grip, your hands need to be spaced out at a distance equal to your shoulder width and for a close grip at a distance smaller than your shoulder width.
3. 3As you have both arms extended in front of you - while holding the bar at the chosen grip width - bring your torso back around 30 degrees or so while creating a curvature on your lower back and sticking your chest out. This is your starting position.
4. 4As you breathe out, bring the bar down until it touches your upper chest by drawing the shoulders and the upper arms down and back. Tip: Concentrate on squeezing the back muscles once you reach the full contracted position. The upper torso should remain stationary (only the arms should move). The forearms should do no other work except for holding the bar; therefore do not try to pull the bar down using the forearms.
5. 5After a second in the contracted position, while squeezing your shoulder blades together, slowly raise the bar back to the starting position when your arms are fully extended and the lats are fully stretched. Inhale during this portion of the movement.
6. 66. Repeat this motion for the prescribed amount of repetitions.

Muscles worked

Primary muscles in filled badges, secondary in grey. Tap for more exercises per muscle.

Tips and common mistakes

• •Keep your core braced and your spine neutral throughout the movement.
• •Add load only once you complete all reps with good form — progressive overload.
• •Initiate the pull from the target muscle rather than jerking with body momentum.
• •Prioritize full range of motion over heavy weight with partial reps.

Sets and reps

For hypertrophy: 3–4 sets × 8–12 reps with 1–2 reps in reserve (RPE 7–9) and 1–2 minutes rest. For strength: 3–5 × 4–6 with longer rest.